Ghost 2 Immobiliser Problems

The Ghost 2 immobiliser, designed to guard cars against key cloning or hacking, is a small device that can be put in place without causing any damage to your vehicle. It stops your vehicle from starting unless you press the correct sequence of buttons inside your vehicle like a password on a mobile phone.

Stop/Start

Ghost immobilisers protect vehicles from being stolen by preventing the engine from running until it has received the correct PIN code. This is done without altering the vehicle, and is undetectable by thieves. The unit is directly connected to the ECU through the CAN databus to immobilise a vehicle. This is the same system that used by car manufacturers for years. However, thieves cannot overcome it using a brand new key, or key relay technology, like they can do with factory fitted systems.

A Ghost can be fitted to any vehicle, van, motorhome, caravan or bike with an engine and is compatible with all the popular brands of vehicles. The same system is compatible with electric cars. It's a great alternative to wheel clamps and steering wheel locks.

When the Ghost is armed it will block all the buttons in your vehicle and stop the ignition from being started unless a PIN code has been entered first. This can be done via the Android or Apple mobile app or by manually entering the code via your key fob. If a wrong code is entered the app will show an indicator light and the Ghost will not allow the vehicle to be started again. This is a great deterrent. in the event that the vehicle cannot be initiated, the criminal will then move on to a different area of.

The ghost 2 immobiliser review is small weatherproof device that can be concealed in the most difficult to reach areas of your vehicle. It is extremely simple to install with an average of 20-30 minutes for each vehicle. It is also simple to take off if you decide to change vehicles, or even give it to a service center or valet parking. It is a TASSA (Tracking and Aftermarket Security Systems Association) insurance-approved system, which what is a ghost immobiliser recognized by a few insurance companies. It also comes with a secure emergency Pin Code Override, and a Service/Valet mode which can be activated by pressing a button within the app or using your key fob.

Disarm

Unlike the mechanical anti-theft devices, which are able to be removed and reinstalled, ghost immobilisers are concealed and integrated into the car. They are near impossible to bypass or hack and even if found, a thief will not be able to start the engine. Ghost immobilisers are able to prevent key cloning, as well as devices spoofing signals and signal jamming. These are methods that thieves employ to gain entry into vehicles equipped that have standard immobilisers.

The immobiliser sends a message to the ECU. If the wrong code is sent the vehicle will not be started as the engine will not fire up. While it is possible to disable the ghost immobiliser by using an application program, this is very time-consuming and difficult. The software must be installednti-hijack function. This is a clever key that protects your car from theft. The Ghost system will automatically turn on the hazard light and stop the car's engine when the ignition is on and the vehicle is stationary. This allows the driver and passengers time to press the security button before the system is activated.

Unlike many competitor systems that simply stop the engine when the ignition is switched on and on, the Ghost system has a unique controller and timer unit which will shut off the valve for cutting off fuel 14 when it is activated after a set period of time, even if the ignition is still turned on! This delay time period must be sufficiently long to allow the victim of the vehicle to drive away from the location of the hijacking and a sufficient distance from the vehicle that is stalled before the system can be activated.

The Ghost comes with added security to prevent common hacking methods used to gain entry to modern cars, such as relay attacks and key range expanding. The Ghost system communicates in a non-intrusive way and does not emit signals that could be snatched by thieves with RF scanning or code-grabbing technology.

The Ghost system also features the Service/Valet mode that allows your vehicle to be temporarily started and driven without the requirement of a PIN code. This is great when you park your vehicle and only require it to be left for a short time in order to open the garage door or put groceries in the boot. The system will exit the service mode based upon speed and time, or via an easy PIN code input process. This will give you complete security that only YOU are able to drive your vehicle!

Keyless Entry

With the rise of car thefts that are not involving contact numerous customers are seeking out additional security options. This is particularly applicable to those who have put time or money into personalising their vehicles and own expensive or rare vehicles. An add-on immobiliser can be an affordable method to stop this kind of theft because it can stop your vehicle from starting unless the right pin code is entered into your key fob.

Immobilisers are designed for various vehicle circuits, including ones that control starter motors and fuel pumps. They also are able to shut off the car alarm in order to draw attention and scare off any potential thieves.

These devices communicate with the engine control unit (ECU) via the CAN data circuit. They also they stop a burglar trying to get around it by installing a new ECU or using the key programmer. These immobilisers are installed discretely inside your vehicle, leaving no trace and are inaccessible to the tools sophisticated thieves use.

The Ghost immobiliser is different from other systems which require drivers to carry a tag or an app. Instead, you can choose your personal pin sequence by pressing a pattern on your door, steering panel, or centre console. The pin can be changed as frequently as you'd like, meaning it is as secure as a credit card, and is even more difficult to break because it requires up to 20 presses.

ghost immobiliser cost also has a Valet/Service mode that allows you to disable the system if your car will be handed over to valet parking or for service, enabling it to work within certain guidelines, such as 30mph speed limits, so you don't have to worry about your vehicle being driven recklessly. The system can be reactivated using the original key or entry code.

Installed by our certified installers and certified installers, it is the most secure and effective aftermarket CAN-immobiliser on the market. It is also accepted by Thatcham for insurance purposes. The Ghost 2 immobiliser is also provided with six QR fingerprint labels, an ISR contact card containing your unique QR code, as well as a secure emergency code which are kept in your purse or wallet of your car.