How to Replace Window Handles

Over time, natural wear and tear from everyday use and environmental factors can cause the window handle to wear down to the point that it requires replacement. It is important to take care of the issue as soon as you observe damage or a decline in functionality.

Replacing a window handle is very straightforward and only involves a few easy steps. Begin by removing the screw cover caps, then take off the screws and the handle.

Replacement Parts

Window handles are a typical wear item on uPVC windows. If you are replacing a window that has broken it is crucial to have the appropriate replacement components, whether you require an espag handle, or a cockspur lock. This will allow you to restore your windows to their original condition and increase the security of your home.

You can locate an alternative uPVC hand here:

Once you have done this you'll need to cut the spindle to the proper size. You can use an angle grinder or hand saw for this. It is crucial to take care when cutting the spindle can result in the window handle not fitting properly or, even more dangerously, falling off completely.

The installation of the new uPVC handle is easy after you've cut the spindle the correct size. It is important to make sure the handle is in the open or locked position while doing this to allow you to reach the screw holes and align with the holes in the old one and then screw them into the hole. After you've installed the new handle, it's a good idea replace the screw covers to prevent dust or debris from entering the holes.

It is worth mentioning at this point that the screws used to install a uPVC window handle may differ from the screws used to remove the window handle, therefore it is advisable to verify upon purchase that you have the correct screws needed to do the job. Fortunately, almost all of the handles in our range include everything you require to replace your old handle and install an entirely new one.

Contact us at Bridgewater Glass if you need assistance or advice on replacing your uPVC windows and bi-fold doors handle. Our experts are on hand to help with any problems you might face and provide professional uPVC window repair services.

Take a measurement of the Spindle

The metal square that runs through the back of the handle, and then into the lock mechanism is called a spindle. The spindle needs to be located before you can replace the handle. It is usually held in place with screws or pins that can be removed with the screwdriver. Before you remove the handle that was previously attached, you should wipe down the area where it's attached to the window frame using a damp cloth. This will help to make the removal process much easier.

Remove the screws or pins off the window frame and the handle. Then, place the new handle in the frame and screw it in. Make sure that the screw holes on the handle and the window frame are aligned. Replace any screw caps that are missing.

Window handles are available in a va, materials and finishes. It is essential to select one that complements the design of your window. It's also important to take into consideration what kind of window you have as some styles will not be compatible with other styles.

Espag handles are usually found on upvc door handle windows and are available in two options of cranked and in-line. In-line handles can be turned left or right and are also known as universal window handles. Cranked handles have a small curving piece in the back, which you can move to open or close the window and they are available in left or right handed versions.

You'll need a handle that is compatible with windows that tilt and turn. They are similar to espagnolette handles, but have an elongated spindle at the rear which sits in the gear box inside the lock mechanism. The diameter of this spindle is usually 7mm, but you can also find handles with a larger cross-section for windows made of timber.

When choosing a handle, you should also think about the step height. This is the distance between the handle's nose and the frame. It is essential to make sure you get it right.

When you have the new handle in place, it's time to test it. You can accomplish this by using the javascript executor to navigate and click on various elements on a website. You'll want to use window handle function, which prints out all handles that are generated by a browser. You can determine the handle of the parent window and then use the child window to perform various actions in a web page. Selenium's guide can help you if you have concerns about the window handle functionality.