How to Change a subaru key car Spare Key

When you lose your Subaru car key, contact a locksmith. Locksmiths usually can cut keys for you at a lower cost than the dealer.

Fob remote "push to start" intelligent keys or a plain metal key are the two most popular types of Subaru car keys. The Fob keys will need to have its chip changed.

Keyless Entry System

The key fob can be used to lock and unlock your Subaru remotely. It can also open the trunk of your car or the lift gate. The remotes use an inside keypad to connect to the computer system of your vehicle.

Some models of Subaru have a feature that is not widely known called PIN Code Access. You can use a customized number sequence to open and start your car. Read the owner's manual to learn how to use this feature if you have a Subaru Forester, Outback Crosstrek, WRX STI or Impreza.

If your keys stop working, there's an excellent possibility that the battery inside the key fob is dead. You can test the battery life of your key fob by using an electronic tester that you can carry around or a multimeter that you have in your garage.

The next step is to remove the key fob from its case and examine the circuit board that controls the transmitter. It will have one or two sets of 8-digit numbers, so jot down the first set so that you can recall it later. Once you've finished take the key fob back together and you'll be ready to begin programming it at home. This procedure differs based on the year and model of your car. However, it is usually easy enough to do yourself.

Key Fobs

Subaru's newest models are all equipped with key fobs that not just open the doors and activate your lights, lock your gas cap, and even start your vehicle. This feature is especially useful if you have ever encountered yourself at a gas station and your car won't even start because the battery in the key fob has died.

It's likely that your Subaru's key fob, regardless of whether it's brand new or old can be replaced easily. It's important to note that models with an advanced level of technological sophistication might require an outing to the dealer. With just a bit of effort and time, you can design your own replacement key fob.

Begin by opening the case and inspecting the circuit board of the transmitter. (Instructions on opening the case are usually included in the owner's manual). There should be two or more serial numbers with 8 numbers each. Keep the first set of numbers in your wallet for later reference.

Then, you'll need to get into the driver's chair and close all doors. Turn the key ten times to start your car, then turn off the engine. Press the lock button on your key fob, then open the door to test that your doors are functioning properly. Close the door, and then remove the key. The chime should be heard from your car, signaling that the key fob has been programmed.

To start, you'll need to locate the small crack in the seam that separates the back and front of your key fob. With a small flathead screwdriver, you can break the seam open and reveal a small compartment which is the battery. Remove the old battery and then insert a new one, making sure it is facing the correct side upwards. Once everything is assembled and you are able to use your new key fob to lock or unlock your vehicle easily!

It's always best to have an extra set of keys available particularly if you've lost yours or not functioning properly. You can purchase a new key from your local dealership or have it cut by locksmiths. It is important to ensure that your key fob functions efficiently as soon as you can so that you can safely drive.