How to Replace a saab ignition key 9-3 Key

The Saab 9-3 is a car that has a large deal of appeal for drivers. It is powerful and has good visibility. It also has an excellent safety rating.

It is vital to have two keys that work for your vehicle. If you lose just one key, it could be expensive to replace it with a new one.

How to Replace the Ignition Key on the saab keys 9-3

You'll have to change your car key in the event that it isn't turning. This guide will show you how to replace the ignition key on a Saab 9-3. You'll have to replace the key, get another reprogrammable device, and then purchase a new casing for your key-fob.

Contrary to earlier models, modern Saab vehicles use a transponder in the key-fob rather than a physical key made of metal to unlock and start the vehicle. The rechargeable batteries contained in the key-fob eventually wear out, and they will not be able to hold charge. This is especially applicable if you are using the same key for the lock you have.

The good news is that it is easily replaced by a professional locksmith. If you've got the right tools and patience you can do it yourself. The first step is to separate the key-fob. This is accomplished by inserting a flathead screwdriver into the slot located in the middle of the case. The plastic is thin, and easily damaged.

Once the case is open then you can prepare the new key by combining the lower portion of the key that was used previously with the transponder and banana on the new key. This will ensure the new key is correctly paired to your CIM and could be a major difference when replacing the sole key for your Saab 9-3.

How to replace the ignition Key on the Saab 900

If you do not have two keys, you'll have to take off the steering wheel and dashboard to gain access to the ignition. Start by disconnecting the negative battery cable. Once the battery is disconnected, you can take off the dashboard and trim pieces that surround the steering wheel. After the dashboard has been removed, you can insert an screwdriver into the opening behind the ignition switch.

The ignition cylinder is equipped with a key lock which can stop the vehicle from starting if you don't have the key inside it. If the ignition switch on your 900 isn't working, check the key to determine whether it's inside the lock or is stuck in the ignition barrel. You should also rotate your keys and keep them clean to prevent bending.

saab fob key replacement cars are different from other cars because they don't utilize traditional metal keys. The car instead recognizes the electric signals generated by the key fob by using the use of a special microchip.

If you lose only one working key fob, the dealer will charge you the highest dollar to replace the computer module (known as the CIM). However, we can reprogram your existing computer's EEPROM and set it to accept new keySaab 93 Key key fob if it is experiencing issues turning the barrel of your lock. It's a simple process and you don't have to visit a dealership. Instead you can do it yourself at home, using just some basic tools.

The first step is to prepare the new key. Before starting, make sure that the anti-theft system is disabled by placing blocks on the rear wheels and releasing the handbrake. Place the key in the ignition and turn it to the "on" position. This will activate the accessories but not start the engine. Repeat this process five times and leave the key in the on position.

You'll then have to buy a new case for your key fob. You can find these at any auto parts shop, and they're typically very affordable. Based on the model, you could even purchase them without electronic components.

To open the case, place an flathead screwdriver into the slot that is in the middle and slowly work it. After you've separated the case, you will have access to all of the internal electronic components. To take the electronics out, make use of a small screwdriver and try prying them out gently.